en/integral-solutions/hydraulic-elevators/" rel="noopener noreferrer">hydraulic elevators require higher demands than those used industrially||en/advantages-of-a-mechanically-synchronized-telescopic-piston/" rel="noopener noreferrer">pistons with mechanical synchronization or hydraulic synchronization||
How hydraulic timing pistons work
Hydraulic synchronisation telescopic pistons have been designed primarily for use in panoramic lifts. The design of these pistons allows the movement of the different sections that make up the piston thanks to internal valves located inside the sections themselves. This design means that the use of other components is not required externally, and therefore gives them an external finish that is highly appreciated by architects and designers, since it facilitates the integration of panoramic lifts in unique buildings.
Where can they be installed?
This is why hydraulic synchronisation pistons are an excellent solution for installations with panoramic lifts, whether in hotels, viewing points, shopping centres, etc., forming part of the neuralgic areas of these buildings (receptions, halls, distributors, etc.). They are usually lifts integrated into the architectural design of the building, in which the lift users not only enjoy using it as a means of transport, but can also see the external movement of the cabin, with the lift itself being an integral part of the design and finish of the building.
Related Posts:
4 comments
GOOD EVENING, I WOULD LIKE TO KNOW IF YOU HAVE REPRESENTATIVES IN THE MEXICAN REPUBLIC.
PLEASE SEND PHONE OR EMAIL.
THANK YOU SO MUCH
Hello, I have a three-section GMV piston and it gets out of sync, it hits the upper sections since they go down before the lower one. What could it be?
A pleasure gentlemen. We have two elevators, one with a single piston and the other with three sections, the lowest one goes out of sync (the lower one goes up) which causes it to knock when we send it to the basement and each time to a higher height. The seals etc. have already been changed by a well-known technician in the field, but a week later it started again. What could be causing this failure? Otherwise it works perfectly.
Hi Victor, what country are you in?